Concrete Pump Concrete Cylinder Disassembled Steps
- Share
- Issue Time
- Jun 24,2026
Concrete Pump Concrete Cylinder Disassembled Steps
1. First, remove both pistons from the water tank (Figure 1).
2. Flatten the swing valve pressure ball valve and release the pressure. Wait until the pressure gauge on the swing valve (Figure 3) shows no pressure before proceeding to the next step (Figures 2 and 3).
3. Disconnect the hoses connecting to the two swing cylinders, the agitator motor hose, and the connected lubricating oil hose (Figures 4 and 5).
4. Remove all six tie rod bolts on the side of the water tank (Figure 6).
5. Remove the six bolts securing the hopper on both sides (Figure 7).
6.After removing all connections, use a forklift to lift the bottom of the hopper and pull it outwards (Figure 8). (Be careful not to touch the discharge switch.)
